Reasons to install Sonic Cleaning in your Application
There are many reasons to use Sonic Cleaning in your Application. Some of them are listed here below.
Boiler Applications
Continuously clean heat transferring surfaces, which means better heat transfer and thus higher steam or hot water production.
Possibility to use less fuel, to produce the same output effect or hot water.
No mechanical wear on the boiler tube surfaces, which means a longer lifetime of about 30% for the boiler tubes.
Traditional steam soot blowers or steel ball cleaning is damaging the boiler tubes a lot.
The sound reaches into every corner, and can thus penetrate tube packages that have been impossible to keep clean with steam soot blowers.
Easy to retrofit into any application.
Cost effective and short payback time.
Catalyst Cell Applications
No mechanical wear on the catalyst cell surfaces, which means a longer lifetime of the catalyst cells.
Traditional steam/air soot blowers are damaging the catalyst cells a lot.
The sound reaches into every corner, and can thus penetrate catalyst cells that have been impossible to keep clean with steam/air soot blowers. For Catalyst Cell Applications - use our SONOFORCE Sonic Soot Blowers
Electro Filter Applications
Uniform cleaning .
No mechanical wear or damage on the electrodes.
Easy to retrofit to improve the filter performance.
Textile Filter Applications
Uniform cleaning of the entire textile bags, which mean improved performance.
No wear on the textile bags, which means longer lifetime.
Cleaning for I.D Fan Applications
Prevent build-up on fan-blades, which means avoiding shutdown, manual cleaning and additional wear. For Cleaning of I.D. Fan Applications - use our SONOFORCE Sonic Soot Blowers
Cyclone Applications
Continuous clean surfaces.
No mechanical wear on the structure.
Avoiding plugging at the outlet.
Marine Applications
No mechanical wear on Boiler tubes or Catalyst cells.
Reduced need for water washing.
No accumulation of soot deposits, which means no stack fires and no soot flakes on deck.
Spray drier Applications
Continuous clean surfaces, which means improved product quality.
No mechanical wear on the structure.
Avoiding plugging at the outlet.
Longer operation time possible between washing.
Minimized waste products left in the Drier at the end of a production cycle.
Silo Applications
To prevent build-ups on the inner walls and roof of a Silo.
Note:
To avoid Bridging of the bulk material, or to get
a Quicker discharge than with other methods,
then use our Pulsator System.
